Hi,
something similar:
In this moment i have just one 10G port configured "like trunk" connected directly to one Extreme brand (like Core) Switch.
I want to do make something similar but not to the same switch so:
What about (remember: Just one controller) with 2 10G ports to 2 switches (Extreme Core Switches and by the way: I´m not the admin of that so...) that are "in Active-Paasive mode using VRRP (layer 3 i guesss) and EAPS (STP propietary for layer 2 i guess)" what configuration do i have to do in the switches (to tell to the extreme guys) and in "my" 7200 controller?
My actual config:
!
interface gigabitethernet 0/0/2
description "GE0/0/2"
trusted
trusted vlan 1-4094
jumbo
switchport mode trunk
switchport trunk native vlan 5
switchport trunk allowed vlan 5,14,16,19,36-37,39,93,97,112,128,135-138,140-144,152,201,207-208,213,216,220-229,234,237-238,248,1038,1128,1192
!
interface gigabitethernet 0/0/3
description "GE0/0/3"
trusted
trusted vlan 1-4094
!
----------
My failed test:
!
interface gigabitethernet 0/0/2
description "GE0/0/2"
trusted
trusted vlan 1-4094
switchport mode trunk
switchport trunk native vlan 5
switchport trunk allowed vlan 5,14,16,19,36,37,39,93,97,128,136,144,152,201,207,208,213,216,224,225,226,227,228,229,234,237,238,248,1038,1128,1192
!
interface gigabitethernet 0/0/3
description "GE0/0/3"
trusted
trusted vlan 1-4094
switchport mode trunk
switchport trunk native vlan 5
switchport trunk allowed vlan 5,14,16,19,36,37,39,93,97,128,136,144,152,201,207,208,213,216,224,225,226,227,228,229,234,237,238,248,1038,1128,1192
!
interface port-channel 1
trusted
trusted vlan 1-4094
switchport mode trunk
switchport trunk allowed vlan 5,14,16,19,36,37,39,93,97,128,136,144,152,201,207,208,213,216,224,225,226,227,228,229,234,237,238,248,1038,1128,1192
!
interface gigabitethernet 0/0/2
description "LACP for 0/0/2 and 0/0/3"
lacp timeout short
lacp group 1 mode active
!
interface gigabitethernet 0/0/3
description "LACP for 0/0/2 and 0/0/3"
lacp timeout short
lacp group 1 mode active
!
Best regards.