Interesting one - but surley proves the IP is valid...
I run a ping to the IP and I get no response, but the show datapath session table shows protocol 1 traffic in both directions - which is ICMP unless I am mistaken.
- What model APs are these?
105
- Can you just confirm that VRRP is working properly? Can you runs "show vrrp" on both controllers just to make sure they are both not active? They are not both active
Virtual Router 20:
Description
Admin State UP, VR State MASTER
IP Address 172.31.200.82, MAC Address 00:00:5e:00:01:14, vlan 1
Priority 120, Advertisement 1 sec, Preemption Enable Delay 1
Auth type PASSWORD, Auth data: ********
tracking is not enabled
Virtual Router 20:
Description
Admin State UP, VR State BACKUP
IP Address 172.31.200.82, MAC Address 00:00:5e:00:01:14, vlan 1
Priority 110, Advertisement 1 sec, Preemption Enable Delay 1
Auth type PASSWORD, Auth data: ********
tracking is not enabled
- Are these APs going to be configured as RAPs or campus APs? You mention the only instance of the MAC is in the when you added it to the RAP whitelist...just want to clarify.
RAP's ultimatly, but just hoping to see them as campus AP's in order to configure them. The only mention of the MAC in the logs was the user commands to add them to the whitelist
- When you run "show ap database long"; do you see it listed at all? Make sure you run it while you can see the TFTP requests in your show datapath session table command you posted.
No - and no chaneg during TFTP traffic
- Do you have existing APs working? Others at this site?
As per previous post - we have plugged in 5 more AP's and now 2 of the 6 are working and provisioned as RAP's successfully.
- Do you have any way of getting to the console of one of those remote APs; just to confirm what the AP is seeing?
Not easily - they are mounted on the side of a building, but as a last resort, I could try to arrange