Hello!
I've converted a RAP-203RP from instant to RAP.
The RAP is allready whitelisted, VPN services are configured and the RAP comes perfectly up (ipsec terminating on master VRRP).
The inner tunnel IP is set over IPSEC address pool on the Master controller.
Now I have also two local controllers.
If I is set the LMS IP in the AP system profile to one of the local controllers, the RAP goes into a boot cycle.
The VPN tunnel also gets established, but only for a view seconds before the RAP boots again.
If I remove the LMS IP configuration RAP boots up normaly.
The only difference between the master and local contoller is, that the IP adress pool is not pushed down from the master to the locals.
Do I have to set the pool on the locals to?
Is it right that the RAP establishes the IPSEC tunnel to the master and the GRE/PAPI tunnels to the LMS IP?
Any suggestions how i can troubleshoot this behavior?
Thank you!