OK - I have got a aruba 620 for lab and using a AP-105 as a RAP
I just want to start basic then layer on extra features later.
Note: I have not done this before!
I got 2 vlans, both trusted. an inside and and outside if you like.
I run the wizard for RAP and provision, and I browse into the RAP and it shows disconnected from the controller
I check datapath tables, I see some udp/4500 traffic, not much.
I see via the console plugged into the 105 - I know it sees the master ip configured right - and the IP address the AP gets is on the same subnet.
The AP never comes up, I even disable control plane security to let any AP register?!
Dont know how to debug this!
Stumped, completely. I can only guess I am missing a massive fundamental thing here. Any suggestions welcome!