I have a VRRP based MASTER-MASTER redundancy, within the same network setup.
Failover for the controllers works well.
I have CAPs and RAPs, and also a seperate Instant network VPN connection within my setup.
I originally had a W-7210 and W-7240 as the two controllers, but recently replaced the W-7240 with a W-7210.
I'm assuming the models are not important in my issue.
As far as I can tell, I have exactly replicated the controller config that I replaced on the new one.
When I intentionally fail the Active controller, the standby picks up as designed. The CAPs move over to the standby(now Master) controller. The VPN connection from my Instant network also gets reestablished.
The only thing wrong is the RAP doesn't reconnect to the new active Master. It stays down.
Manually rebooting the RAP doesn't help either.
I've reset the Instant and converted it to a RAP again, after completing the controller replacement. I did this just in case there was seom behind the scenes database info that replacing one of the controllers woudl cause an issue.
Is there anything I'm missing or can check?
The RAP console only says "Transport endpoint is not connected"
Othe than that it correctly uses ADP to find/confirm the Master.
Regards,
Colin