Wireless Access

Hello Guys

I installed a  Mobility controller in stand alone on a virtual machine

I installed the fallowing licenses on the controller on stand alone

AP,PEF, RFP, and  MC-VA-US

This is for  a LAB and i got these license for lab purpuses demo licenses.

The thing is that the AP wont go up and its telling me that it has no license... even if i can see that all the license are installed and witht he check mark

Its telling me its not using any license.

I did the same with a physical controller with a ap pef and a rfp license and worked fine no issue.

Now i was wondering  it says MC-VA-US but my ap is RW,  is there any issue with this?? or any ideas what could be the problem?

Cheers

Carlos

I think (all most sure;)) this make sence and you have to use the same regulator domain. Dont mix MC-VA-US license with AP-RW access points. Can you install a MC-VA-RW licence?

Thats really odd beacuse my SE gave me those licenses....

Any from aruba can confirm if MC-VA-US vm controller does not work with RW aps ?

Cheers

Carlos

Iam sure your SE pick the wrong one ;) ...Or if your are live in US you have the wrong AP.

https://www.arubanetworks.com/techdocs/ArubaOS_83x_Web_Help/Content/PDFs/ArubaOS_8.3.0.x_Licensing_Guide.pdf

Hello Marcell, im asking for the RW license, thanks.

Ajay

Here is the output for you, its like it has no license, so its icative aka... 2IL

(VM1) [mynode] #show ap database

AP Database
-----------
Name         Group         AP Type  IP Address    Status    Flags  Switch IP       Standby IP
----         -----         -------  ----------    ------    -----  ---------       ----------
AP_215_TEST  WIFI_TEST  215      172.16.151.2  Up 3m:4s  2IL    172.16.150.250  0.0.0.0

Flags: 1 = 802.1x authenticated AP use EAP-PEAP; 1+ = 802.1x use EST; 1- = 802.1x use factory cert; 2 = Using IKE version 2
       B = Built-in AP; C = Cellular RAP; D = Dirty or no config
       E = Regulatory Domain Mismatch; F = AP failed 802.1x authentication
       G = No such group; I = Inactive; J = USB cert at AP; L = Unlicensed
       M = Mesh node
       N = Duplicate name; P = PPPoe AP; R = Remote AP; R- = Remote AP requires Auth;
       S = Standby-mode AP; U = Unprovisioned; X = Maintenance Mode
       Y = Mesh Recovery
       c = CERT-based RAP; e = Custom EST cert; f = No Spectrum FFT support
       i = Indoor; o = Outdoor; s = LACP striping; u = Custom-Cert RAP; z = Datazone AP
       p = In deep-sleep status
       4 = WiFi Uplink

Total APs:1
(VM1) [mynode] #