Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Viewing AP Group settings from the AP

This thread has been viewed 1 times

  • 1.  Viewing AP Group settings from the AP

    Posted Dec 16, 2018 01:52 PM

    Dear Experts, 

     

    When we change any setting in AP Group, such as lms-ip/backup-lms ip, is there anyway to see it from the AP itself if console is enabled? can anyone share the command for it?



  • 2.  RE: Viewing AP Group settings from the AP
    Best Answer

    EMPLOYEE
    Posted Dec 16, 2018 05:02 PM

    On the commandline of the controller you would type:

     

    show ap config ap-name <name of ap>

    That will tell you what configuration is applied to that access point. 



  • 3.  RE: Viewing AP Group settings from the AP

    Posted Dec 17, 2018 01:21 AM

    Dear Colin, 

     

    Thanks for the prompt response. Out of curiosity, is there anyway to check from the console of AP itself?



  • 4.  RE: Viewing AP Group settings from the AP

    EMPLOYEE
    Posted Dec 17, 2018 04:32 AM

    Some parameters, yes, but the the information from the console is typically for engineering (undecipherable) and scattered all over the place.  Is there a problem with viewing it on the controller?