Wireless Access

last person joined: 3 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Virtual MM and ports/VLAN GUI display issue

This thread has been viewed 0 times

  • 1.  Virtual MM and ports/VLAN GUI display issue

    Posted Oct 28, 2018 10:05 AM

    MC-Configuration-Interfaces-VLANs(tab)MC-Configuration-Interfaces-VLANs(tab)MC-Configuration-Interfaces-Ports(tab)MC-Configuration-Interfaces-Ports(tab)Hi all,

    I am facing an issue in the display of VLANs and Ports within the MM's GUI interfaces.

    As shown:

    In the ports (tab): GE0/0/0 is displayed as configured trunk port & native vlan 300

    While in the VLANs (tab): GE0/0/0 is NOT a member of any VLAN ???

     

    Is this an issue? or if this is normal, what is the logic behind this???

     

    Thanks/Shady



  • 2.  RE: Virtual MM and ports/VLAN GUI display issue

    EMPLOYEE
    Posted Oct 29, 2018 06:13 PM
    @Shady.Hassan wrote:

    Hi all,

    I am facing an issue in the display of VLANs and Ports within the MM's GUI interfaces.

    As shown:

    In the ports (tab): GE0/0/0 is displayed as configured trunk port & native vlan 300

    While in the VLANs (tab): GE0/0/0 is NOT a member of any VLAN ???

     

    Is this an issue? or if this is normal, what is the logic behind this???

    Historically, under VLANs, only access ports are listed since they are associated with a single VLAN. Trunk ports have not been listed.