Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Warning when trying to change some features on ARM

This thread has been viewed 1 times

  • 1.  Warning when trying to change some features on ARM

    Posted Feb 28, 2020 02:16 PM 
    Warning: If there is an entry for a radio in 'ap spectrum local-override' profile on the local controller that terminates the AP, that entry will override the mode selection in the radio profile.

     

    Im getting this warning everytime i try to change something like:  Use 802.11h 802.11d on 802.11g and 802.11a

     

    Whats that? someone can explain in to me? maybe im just not getting it because limited english understanding.

     

    Thanks



  • 2.  RE: Warning when trying to change some features on ARM
    Best Answer

    MVP GURU
    Posted Feb 28, 2020 02:25 PM

    Its just warning you that the change will not effect an AP if it has AP specific configuration. The AP specific configuration will be used over the ap-group config.



  • 3.  RE: Warning when trying to change some features on ARM

    MVP EXPERT
    Posted Feb 28, 2020 02:25 PM

    Its just an informational message you don't have any spectrum override configured. You can ignore it.



  • 4.  RE: Warning when trying to change some features on ARM

    Posted Feb 28, 2020 02:48 PM

    Thank you 2