Wireless Access

Super Contributor II

What would be the load balancing technique for both links on the AP 220?

The spec sheet for this implies that the ports will have the ability to be aggregated to provide 1.9Gbps of throughput. Assuming that the device was connected to another aruba device, does anyone know what would be the load balancing technique used to send frames down either or both links. Any idea if this would be configurable?

Guru Elite

Re: AP220 Controller

The 225 will create a GRE tunnel for each VAP.

Two IP addresses are used by the controller, X and X+1.

Currently all 5G radio traffic uses the main address (X) and the 2.4 radio
uses the X+1 address.

You can then set the edge switch to do port channel load balancing based on
source IP.

| Tim Cappalli | Aruba Security | @timcappalli | timcappalli.me |

NOTE: Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba or Hewlett Packard Enterprise.
Search Airheads
Showing results for 
Search instead for 
Did you mean: