Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

high Amplitude

This thread has been viewed 0 times

  • 1.  high Amplitude

    Posted May 16, 2013 11:37 PM
      |   view attached

    Hi

     

    i have question about  figure ,

     

    The Circle on figure is power of signal from Acess Point  name "three three engineer"  that radiate to client on channel 6   and  -40 dbm = .0000989 mW Signal or not ?

     

    thx you for anwser !!   :smileyhappy:

    Spoiler
     

     

     



  • 2.  RE: high Amplitude

    Posted May 17, 2013 05:06 AM

    Yes, -40dBm is 0.0001 mW.

    Regarding the signal on the picture I am not sure that it is coming from the AP. Is this a constant signal you see or it was just a temporary peak when you took the screenshot? What is this software? Btw it says -83 for that SSID and it is on channel 6 where you should see the most power.



  • 3.  RE: high Amplitude

    Posted May 17, 2013 06:04 AM

    Yes ,  it was just a temporary peak    and  will shown every 1 sec

     

    I'm  use  Metageek channelyzer Pro  :smileyhappy:



  • 4.  RE: high Amplitude

    Posted May 17, 2013 06:17 AM

    It can be even a non Wi-Fi interference. As far as I know that software can classify devices amongst many other useful feature. Can you see this peak only at that frequency?