Wireless Access

last person joined: 8 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

non wifi interference

This thread has been viewed 3 times

  • 1.  non wifi interference

    Posted Oct 19, 2012 12:12 AM

    Hi,

     

    How can I mitigate non wifi interference or configure non wifi immunity.

     

    Thanks

     



  • 2.  RE: non wifi interference
    Best Answer

    EMPLOYEE
    Posted Oct 19, 2012 01:04 AM

    Interference immunity is located in the ARM profile, but it should only be changed with the help of support, because it decreases coverage.

     



  • 3.  RE: non wifi interference

    Posted Oct 19, 2012 02:15 AM

    Thanks, could you let me know where in ARM profile, I couldnt see ARM in GUI.



  • 4.  RE: non wifi interference
    Best Answer

    Posted Oct 19, 2012 11:41 PM

    ARM profiles are located under All Profiles --> RF Management --> Adaptive Radio Management (ARM) Profile; they are then applied to the appropriate AP Group.    However, the Non-wifi Inteference Immunity settings are found in the 802.11g and 802.11a radio profiles respectively.    But as Colin mentioned, these settings should be changed with care (and usually with the backing of Aruba support). 

     

    The following may also provide good references:

     

    http://community.arubanetworks.com/aruba/board/message?board.id=campus-wlan-and-high-density-wi-fi&message.id=459#M459