Wireless Access

Reply
Occasional Contributor II

show ap arm neighbors ...

Hi,

 

I have dual-band APs (125 & 105) running in air monitor mode on the 2.4 radios and ap mode on the 5.0 radios.  When invoking "show ap arm neighbors ip-addr <ap ip address>", I am seeing only the neighbors from the 5.0 radio.  Shouldn't I be seeing neighbors on the 2.4 band as well?

 

Though ome controllers are running versions 3.4.2.5 of AOS, while others are running 6.1.2.6, the result is still the same for the 2.4 AM access points-neighbors on 5.0, and nothing on 2.4.

 

Thanks in advance,

 

John

 

 

 

 

Guru Elite

Re: show ap arm neighbors ...


u35828 wrote:

Hi,

 

I have dual-band APs (125 & 105) running in air monitor mode on the 2.4 radios and ap mode on the 5.0 radios.  When invoking "show ap arm neighbors ip-addr <ap ip address>", I am seeing only the neighbors from the 5.0 radio.  Shouldn't I be seeing neighbors on the 2.4 band as well?

 

Though ome controllers are running versions 3.4.2.5 of AOS, while others are running 6.1.2.6, the result is still the same for the 2.4 AM access points-neighbors on 5.0, and nothing on 2.4.

 

Thanks in advance,

 

John

 

 

 

 




 

Are you sure it is AM?  did you type "show ap active"?

 


*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.3 User Guide
InstantOS 8.3 User Guide
Airheads Knowledgebase
Airheads Learning Videos
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: