Hello,
two tagged VLANs were configured on a JG963A. One VLAN for the intranet and one VLAN for VoIP. I would like to set up QoS rules for the Voip VLAN.
In the instructions you will find configuration examples for QoS with this description:
a. From the navigation tree, select QoS > QoS > QoS Policy.
b. Apply a QoS policy to the incoming traffic of GigabitEthernet 1/0/2.
I can still select the port in the web interface, "WebVLAN_200_1" is specified for the name of the policy (wherever that comes from), the "Incoming Mode" is unknown to me.
The following points then follow in the instructions:
c. Access the details page for the QoS policy to modify the applied QoS policy as follows:
− Create IPv4 ACL 2000, and add a rule to permit packets with source IP address
192.168.1.0 and mask 0.0.0.255.
− Configure the ACL as a match criterion of a class, and specify the associated behavior
to mark the matched packets with 802.1p priority 0.
These cannot be found even if I have created a test rule.
Is there a different guide or a better example?
Many Thanks.
greeting
Mark
------------------------------
Markus Müller
------------------------------