Hi cjoseph,
Four months ago, here I discussed here in this forum a problem with my AP-135. The problem was entirely my because I had only AP-135 instead of IAP-135. Now I have both, I haven't problems with the new IAP-135 and configured it very quickly. Not completely but the main one is done. Thank you very much for the useful information, this is my little but my main pass.
So, now I'm trying to connect my old AP-135 to the new IAP-135. This message for "CLI module is running in a degraded state" dissapear. But unfortunately:
- I do not see it on the IAP-135 website.
- I can not enter my page because admin / admin is not working. My admin accounts too.
Current Facts:
- My IAP-135 is already configured with the "iap-master" command in its CLI.
- The AP-135 is attached both directly to the local network and as chain via ETH1 port of the IAP-135's.
- MAC address of both devices is configured in my DHCP server and they take their IP-ta desired by me. (172.16.0.20 анд 172.16.0.21)
- I did factory reset.
- Both devices IAP-135 and AP-135 has same version of firmware:
ArubaOS Version 6.4.4.4-4.2.3.2 (build 54910 / label #54910)
None of the above hasn't helped.
Something I miss and do not know what, can you help me?
Log of my serial console is attached to this post.
Thanks a lot in advance.
~Dinko