Become a Member
Hi, I'm very new to HPE networking, and recently we have purchased HPE Aruba 2930F JL255A network switch. We would like to configured it as network default gateway instead of using firewall IP as default gateway. I did some research and most common method is configure ip route 0.0.0.0/0 ....
Hi forum Im looking for a command in comware 7 what will enable BGP to exchange internal routes between iBGP peers. Basically the same as "bgp redistribute internal" does in a CISCO Thanks in advance #route #Internal #BGP #iBGP
Hi, I need to check (icmp) an IP not directly connected to an HP 3810M switch to change a route. I know I could do it via OSPF but I can not in the actual context. Is that it is possible to do so, or is there any firmware/release -16.1 ?/ upgrade prediction to do so. (NQA comware feature...
What I want to say is whether the SW works only over the mac address layer, what is the point to insert a route using the network layer if the box does not understand IP address? I know that this switch model is a bit powerful than the default L2 switches but I don't want this box (1910) working...
Hi. When you use a bridge interface you also utilize spanning tree protocol (STP) if enabled. A route interface does not utilize STP. Usually in comware you can access the sub interface configuration but specifing it with a dot. First you should set the parent (physical) interface in...